BATTERY MONITOR BMV-700

C$219.00
Availability: On backorder

The Victron BMV-700 Battery Monitor's function is to calculate ampere-hours consumed and the state of charge of a battery.

Ampere-hours consumed is calculated by integrating the current flowing in or out of the battery. In case of a constant current, this integration is equivalent to current multiplied by time.

A discharge current of 10A during 2 hours, for example, amounts to 20Ah consumed. All Victron Battery Monitors are based on a powerful microprocessor, programmed with the algorithms needed for this precision monitoring.

 
Standard Features:
  • Battery voltage (V).
  • Battery charge/discharge current (A).
  • Ampere-hours consumed (Ah).
  • State of charge (%).
  • Time to go at the current rate of discharge.
  • Visual and audible alarm: over- and under voltage, and/or battery discharged.
  • Programmable alarm or generator start relay.
Low Cost Ultra High Resolution Monitor
  • Highest resolution: 10mA (0,01A) with 500A shunt.
  • Can be used with 50, 60 or 100mV shunts, current rating from 100A to 1000A
  • Lowest current consumption: 4mA @12V and 3mA @ 24V.
  • Easiest to wire: comes with shunt, 10 meter RJ 12 UTP cable and 2 meter battery cable with fuse; no other components needed.
  • Easiest to install: separate front bezel for square or round appearance; ring for rear mounting and screws for front mounting.
  • Broadest voltage range: 9.5 – 95 VDC without prescaler needed.
  • Communication port (Isolated RS232 interface is needed to connect to a computer) for Optional Interface & Software

battery.

0 stars based on 0 reviews